Q-Series Support

Video: Sliding Tool Rack Bearing Block Replacement
This video will show you how to replace the sliding tool rack bearing blocks
Watch Video
Video: Gantry Tightening Procedure
This video will show you how to tighten and adjust the alignment of the Gantry
Watch Video

Setting The Hitachi VFD Deceleration Time
Occasionally when using very large form and cabinet making bits that weigh a lot, you might need to adjust the time it takes for the spindle to decelerate so it is stopped before tool changes.
Watch Video
Q.404 and Q.408 Y-Axis Ball Screw Alignment
This video will show you how to properly align the Y axis ball screws on Q-Series machines
Watch Video
Installing the Hitachi VFD Controller Faceplate
This video will show you how to install the VFD controller faceplate on older style Hitachi VFD units with the NES1-OP panel
Watch Video
Q.204 Ballscrew and Gantry Alignment
A quick video showing how to align the gantry and adjust the ball screws
Watch Video
Replacing Silicone Strips on Y-Axis
This video will show you how to replace worn out silicone profile strips on the Y-Axis
Watch Video
Installing The Sliding Tool Rack
If you order a sliding tool rack at a future date from when you get your machine, this video will show you how to install it.
Watch Video